Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards

Optical Cards

Table D-163

Field Descriptions for the Input Power Tab (continued)

 

 

 

Field

 

Description

 

 

 

Fail

 

Sets the fail threshold for the Laser 1 input power, in dBm, and the alarm severity level.

 

 

 

Degrade

 

Sets the degrade threshold for the Laser 1 input power, in dBm, and the alarm severity level.

 

 

 

High

 

Sets the high threshold for the Laser 1 input power, in dBm, and the alarm severity level.

 

 

 

Note See Table 1-20 on page 1-44for descriptions of actions that can be performed using the buttons at the bottom of the window.

D.4.11 Slot Properties—S1.1-2-LC (ONS 15305 CTC)

The Slot Properties pane displays information about the Cisco ONS 15305 CTC slot that is selected in the NE Explorer tree. Use this properties pane to change the module performance monitoring thresholds.

The two optical STM-1 interfaces use a dual-fiber interface, an LC-style connector, one fiber in each direction, 1310 nm wavelength, and single-mode fiber of type 10/125 nm. The optical interfaces are compatible with ITU-T 957 for S-1.1.

The interface is an optical STM-1 short-haul interface, according to clause 5 ITU-T G.957. The definitions of optical parameters and reference points S and R refer to ITU-T G.957. Reference point S is the transmit direction; reference point R is the receive direction of the fiber. A module diagram is shown in the following figure.

Figure D-2 S1.1-2-LC Module

S16.1-2-LC

MOD

FAIL

OUT IN

OUT IN

1

2

CLASS 1

LASER

PRODUCT

MOD

DIS

96699

For the S1.1-2-LC module, the Slot Properties pane displays the following tabs: Module View, Identification, STM Line, VC-4 Config, and Loopback. The tabs shown depend on the NE configuration.

D.4.11.1 Module View Tab

The Module View tab displays a graphic of the S1.1-2-LC that is installed in the slot. The number of critical, major, minor, and warning alarms for the module is displayed under Alarm Status. (Alarms are also displayed when you move the mouse pointer over the graphic.) The Suppress Alarms check box is read-only and indicates whether all alarms are suppressed for the card and its port(s).

 

Cisco Transport Manager Release 7.2 User Guide

D-156

78-17630-01

Page 156
Image 156
Cisco Systems 78-17630-01 appendix Slot Properties-S1.1-2-LC ONS 15305 CTC, 156