Cisco Systems 78-17630-01 appendix Table D-99 Field Descriptions for the Line Tab

Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards

Optical Cards

Table D-98 Field Descriptions for the Identification Tab (continued)

Field	Description
Equipment State	Displays the equipment state of the card.
Alarm Profile	Sets the alarm profile for the port. Check the Suppress Alarms check box to suppress all
	alarms for this card and its port(s).

D.4.3.3 Line Tab

The Line tab allows you to view and update OC192 LR/STM64 LH 1550 optical line performance monitoring information.

Table D-99 Field Descriptions for the Line Tab

Field	Description
Line Config
Port Number	Displays the optical port number.
Port Name	Allows you to enter an optical port name.
SD BER	Sets the signal degrade bit error rate.
SF BER	Sets the signal fail bit error rate.
Type	Defines the port as SONET or SDH.
PJSTSMon#	Sets the STS that will be used for pointer justification. If set to 0, no STS is monitored. Only one
	STS can be monitored on each OC-N port.
	• 0 (Cisco default)–3 (OC-3, per port)
	• 0 (Cisco default)–12 (OC-12)
	• 0 (Cisco default)–48 (OC-48)
ProvidesSync	If checked, the card is provisioned as an NE timing reference.
EnableSyncMsg	Enables synchronization status messages (S1 byte), which allow the node to choose the best timing
	source.
Admin SSM	If the node does not receive an SSM signal, it defaults to STU (synchronization traceability
	unknown). Admin SSM allows you to override the STU value with one of the following:
	• PRS—Primary reference source (Stratum 1)
	•	STS2—Stratum 2
	•	TNC—Transit node clock
	•	STS3E—Stratum 3E
	•	STS3—Stratum 3
	•	SMC—SONET minimum clock
	•	ST4—Stratum 4
Send DoNotUse	When checked, sends a do not use (DUS) message on the S1 byte.
Admin State	Select the designation that drives whether an entity is in service or out of service. The Admin state
	is the driver for the Service state.

	Cisco Transport Manager Release 7.2 User Guide
78-17630-01		D-87