Appendix D Slot Property
Optical Cards
D.4.19.2 Identification Tab
The Identification tab allows you to view and update
Table | Field Descriptions for the Identification Tab | |
|
|
|
Field |
| Description |
|
|
|
Equipment Type |
| Displays the equipment type the slot is provisioned for. |
|
| |
Actual Equipment Type | Displays the actual card that is installed in the slot. | |
|
|
|
Part Number |
| Displays the card part number that is printed on the top of the card. |
|
| |
Hardware Revision | Displays the hardware revision number of the card. | |
|
|
|
Serial Number |
| Displays the card serial number that is unique to each card. |
|
|
|
CLEI Code |
| Displays the CLEI code. |
|
| |
Firmware Version | Displays the revision number of the software used by the ASIC chip installed on the card. | |
|
|
|
Equipment State |
| Displays the equipment state of the card. |
|
|
|
Alarm Profile |
| Sets the alarm profile for the port. Check the Suppress Alarms check box to suppress all alarms |
|
| for this card and its port(s). |
|
|
|
D.4.19.3 Line Tab
| The Line tab allows you to view and update | |
| information. | |
Table | Field Descriptions for the Line Tab | |
|
|
|
Field |
| Description |
|
|
|
Line Config |
|
|
|
|
|
Port Number |
| Displays the optical port number. |
|
|
|
Port Name |
| Allows you to enter an optical port name. |
|
|
|
SD BER |
| Sets the signal degrade bit error rate. |
|
|
|
SF BER |
| Sets the signal fail bit error rate. |
|
|
|
Type |
| Defines the port. |
|
|
|
| Sets the VC that will be used for pointer justification. If set to 0, no VC is monitored. Only one | |
|
| VC can be monitored on each STM port. |
|
|
|
ProvidesSync |
| If checked, the card is provisioned as an NE timing reference. |
|
|
|
EnableSyncMsg |
| Enables synchronization status messages (S1 byte), which allow the node to choose the best |
|
| timing source. |
|
|
|
Send DoNotUse |
| When checked, sends a DNS (do not use) message on the S1 byte. |
|
|
|
Admin State |
| Select the designation that drives whether an entity is in service or out of service. The Admin |
|
| state is the driver for the Service state. |
|
|
|
| Cisco Transport Manager Release 7.2 User Guide |
|
