D-123
Cisco Transport Manager Release 7.2 User Guide
78-17630-01
AppendixD Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards Optical Cards
D.4.6.3 Line Tab
The Line tab allows you to view and update OC3 IR/STM1 SH 1310-8 optical line performance
monitoring information.
TableD-129 Field Descriptions for the Line Tab
Field Description
Line Config
Port Number Displays the optical port number.
Port Name Allows you to enter the name of the optical port.
SD BER Sets the signal degrade bit error rate.
SF BER Sets the signal fail bit error rate.
Type Defines the port as SONET or SDH.
PJSTSMon# Sets the STS that will be used for pointer justification. If set to 0, no STS is monitored. Only one STS
can be monitored on each OC-N port.
•0 (Cisco default)–3 (OC3, per port)
•0 (Cisco default)–12 (OC-12)
•0 (Cisco default)–48 (OC-48)
ProvidesSync If checked, the card is provisioned as an NE timing reference.
EnableSyncMsg Enables synchronization status messages (S1 byte), which allow the node to choose the best timing
source.
Send DoNotUse When checked, sends a do not use (DUS) message on the S1 byte.
Admin State Displays the status of the line. The line can be In Service (IS), In Service–Auto In Service Soak
(IS_AINS), Out of Service (OOS), or Out of Service–Maintenance (OOS_MT).
AINS Soak Automatic in-service soak. The determination of duration left before the traffic/termination
transitions to IS state.
AINS Soak Count
Down Automatic in-service soak countdown. Displays the remaining time of valid input signal inhh:mm,
after which the card becomes in service (IS) automatically.
ALS Mode Allows you to select the ALS mode (Disabled, Auto Restart, Manual Restart, or Manual Restart for
Test). ALS is a laser safety feature defined by ITU G.664.