Cisco Systems 78-17630-01 appendix 183

Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards

Optical Cards

Table D-202		Field Descriptions for the Line Tab (continued)
	Field		Description
	SD BER		Sets the signal degrade bit error rate.
	SF BER		Sets the signal fail bit error rate.
	ProvidesSync		If checked, the card is provisioned as an NE timing reference.
	EnableSyncMsg		Enables synchronization status messages (S1 byte), which allow the node to choose the best timing
			source.
	Send DoNotUse		When checked, sends a DNS (do not use) message on the S1 byte.
	Admin State		Select the designation that drives whether an entity is in service or out of service. The Admin state is
			the driver for the Service state.
	Service State		Displays the service state:
			•	IS_NR—In Service–Normal.
			•	OOS_AU—Out of Service–Autonomous.
			•	OOS_MA—Out of Service–Management.
			• OOS_AUMA—Out of Service–Autonomous and Management.
			In addition, a secondary state provides additional information about the status of the entity. Values for
			secondary state are:
			• MEA—Mismatch of equipment due to invalid equipment insertion.
			• UEQ—Unequipped; there is nothing in the slot.
			• UAS—Unassigned; the entity does not exist, has not been created, or has been deleted.
			• SWDL—Software download in progress.
			• MT—Maintenance, as per the Admin State change.
			•	AINS—Automatic in service.
			• DSBLD—Traffic is disabled on the entity.
			• LPBK—Port or connection has a loopback on it.
			• FLT—Fault secondary state. When an entity is faulted, an FLT state is raised. Equipment and ports
				in FLT state should be cleared as they transition. Transition states are listed in Table 11-10 on page
				11-15.
			See Table 11-10 on page 11-15for the Service state/Secondary state possible values.
			Note If the NE does not support the Service State, this field shows N/A.
	Synchronization		SDH protocol that communicates information about the quality of the timing source.
	Status Message
	MS-SPRing Ext.		Select an alternate MS-SPRing byte.
	Byte
	Type		Defines the port.
	MS Thresh 15 Min (Near End)
	Port Number		The port number
	EB-MS		Errored block–multiplex section
	ES-MS		Errored seconds–multiplex section
	SES-MS		Severely errored seconds–multiplex section
				Cisco Transport Manager Release 7.2 User Guide
	78-17630-01				D-183