D-130
Cisco Transport Manager Release 7.2 User Guide
78-17630-01
AppendixD Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards
Optical Cards
D.4.7.2 Identification Tab
The Identification tab allows you to view and update OC48 identification information.
D.4.7.3 Line Tab
The Line tab allows you to view and update OC48 optical line performance monitoring information.
TableD-137 Field Descriptions for the Identification Tab
Field Description
Equipment Type Displays the equipment type the slot is provisioned for.
Actual Equipment Type Displays the actual card that is installed in the slot.
Hardware Part Number Displays the card part number that is printed on the top of the card.
Hardware Revision Displays the hardware revision number of the card.
Serial Number Displays the card serial number that is unique to each card.
CLEI Code Displays the CLEI code.
Firmware Version Displays the revision number of the software used by the ASIC chip installed on the card.
User Code Allows you to enter an ASCII string to identify the card. The user code is stored in
nonvolatile memory so that it is not lost when the unit is moved or stored as a spare.
Product ID Displays a product ID string of 63 characters maximum. If the card does not support the
product ID, the field shows N/A.
Version ID Displays a version ID string in the format “V99_.” The version ID always begins with a V
and ends with a space. If the card does not support the version ID, the field shows N/A.
Equipment State Displays the equipment state of the card.
Alarm Profile Sets the alarm profile for the port. Check theSuppress Alarms check box to suppress all
alarms for this card and its port(s).
TableD-138 Field Descriptions for the Line Tab
Subfield Description
Line Config
Port Number Displays the optical port number.
Port Name Allows you to enter the name of the optical port.
SD BER Sets the signal degrade bit error rate.
SF BER Sets the signal fail bit error rate.
ProvidesSync If checked, the card is provisioned as an NE timing reference.
EnableSyncMsg Enables synchronization status messages (S1 byte), which allow the node to choose the best
timing source.
Send DoNotUse When checked, sends a do not use (DUS) message on the S1 byte.
Admin State Selectthe designationthat driveswhether anentity is in service or out of service. The Admin
state is the driver for the Service state.