Cisco Systems 78-17630-01 appendix Table D-108 Field Descriptions for the Line Tab

Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards

Optical Cards

Table D-108 Field Descriptions for the Line Tab

Field		Description
Line Config
Port Number		Displays the optical port number.
Port Name		Allows you to enter the name of the optical port.
Admin State		Displays the status of the line. The line can be In Service (IS), In Service–Auto In Service Soak
		(IS_AINS), Out of Service (OOS), or Out of Service–Maintenance (OOS_MT).
Service State		Overall availability of the entity. Values are:
		•	IS_NR—In Service–Normal.
		•	OOS_AU—Out of Service–Autonomous.
		•	OOS_MA—Out of Service–Management.
		• OOS_AUMA—Out of Service–Autonomous and Management.
		In addition, a secondary state provides additional information about the status of the entity. Values
		for secondary state are:
		• MEA—Mismatch of equipment due to invalid equipment insertion.
		• UEQ—Unequipped. There is nothing in the slot.
		• UAS—Unassigned. The entity does not exist, has not been created, or has been deleted.
		• SWDL—Software download in progress.
		• MT—Maintenance, as per the Admin State change.
		•	AINS—Automatic In Service.
		• DSBLD—Traffic is disabled on the entity.
		• LPBK—Port or connection has a loopback on it.
		• FLT—Fault secondary state. When an entity is faulted, an FLT state is raised. Equipment and
			ports in FLT state should be cleared as they transition. Transition states are listed in Table 11-10
			on page 11-15.
		See Table 11-10 on page 11-15for the Service state/Secondary state possible values.
		Note If the NE release does not support the Service state, this field shows N/A.
SF BER		Sets the signal fail bit error rate.
SD BER		Sets the signal degrade bit error rate.
ProvidesSync		If checked, the card is provisioned as an NE timing reference.
EnableSyncMsg		Enables synchronization status messages (S1 byte), which allow the node to choose the best timing
		source.
Send DoNotUse		When checked, sends a do not use (DUS) message on the S1 byte.
BLSR Ext. Byte		Select an alternate BLSR byte. Choices are Z2, E2, or F1.
Type		Defines the port as SONET or SDH.
AINS Soak		Automatic in-service soak. The determination of duration left before the traffic/termination
		transitions to IS state.
AINS Soak Count		Automatic in-service soak countdown. Displays the remaining time of valid input signal in hh:mm,
Down		after which the card becomes in service (IS) automatically.
	Cisco Transport Manager Release 7.2 User Guide
D-96			78-17630-01