D-198
Cisco Transport Manager Release 7.2 User Guide
78-17630-01
AppendixD Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards
Optical Cards
D.4.21.3 STM Line Tab
The STM Line tab allows you to view and update L16.2-1-LC optical line performance monitoring
information.
D.4.21.4 VC-4 Config Tab
The VC-4 Config tab allows you to view and update L16.2-1-LC VC-4 configuration information.
TableD-220 Field Descriptions for the Identification Tab
Field Description
Equipment Type Displays the equipment type the slot is provisioned for.
Actual Equipment Type Displays the actual card that is installed in the slot.
HW Part Number Displays the card part number that is printed on the top of the card.
Hardware Revision Displays the hardware version number.
Serial Number Displays the card serial number that is unique to each card.
CLEI Code Displays the CLEI code.
Firmware Version Displaysthe hardwarerevision numberof the software used bythe ASIC chip installed onthe
card.
Product ID Displays a product ID string of 63 characters maximum. If the card does not support the
product ID, the field shows N/A.
Version ID Displays a version ID string in theformat “V99_.” The versionID always begins witha V and
ends with a space. If the card does not support the version ID, the field shows N/A.
Equipment State Displays the equipment state of the card.
Alarm Profile Displays the alarm profile for the port.
TableD-221 Field Descriptions for the STM Line Tab
Field Description
Port Number Displays the optical port number.
Port Name Allows you to enter an optical port name.
ProvidesSync If checked, the card is provisioned as an NE timing reference.
EnableSyncMsg Enablessynchronization status messages (S1 byte), which allow the node to choose the best timing
source.
Send DoNotUse When checked, sends a DNS (do not use) message on the S1 byte.
Admin State Shows the administrative state of the port: In Service (IS) or Out of Service (OOS).
TableD-222 Field Descriptions for the VC-4 Config Tab
Field Description
VC Number Displays the VC number.
IPPM Enabled Check to enable intermediate path performance monitoring (IPPM) and uncheck to disable IPPM.
XC Loopback Indicates cross-connect loopback.