Cisco Systems 78-17630-01 appendix Sf Ber

Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards

Multirate Cards

Table D-51	Field Descriptions for the Line Config Subtab (continued)
Field		Description
Service State		Overall availability of the entity. Values are:
		•	IS_NR—In Service–Normal.
		•	OOS_AU—Out of Service–Autonomous.
		•	OOS_MA—Out of Service–Management.
		• OOS_AUMA—Out of Service–Autonomous and Management.
		In addition, a secondary state provides additional information about the status of the
		entity. Values for secondary state are:
		• MEA—Mismatch of equipment due to invalid equipment insertion.
		• UEQ—Unequipped. There is nothing in the slot.
		• UAS—Unassigned. The entity does not exist, has not been created, or has been
			deleted.
		• SWDL—Software download in progress.
		• MT—Maintenance, as per the Admin State change.
		•	AINS—Automatic In Service.
		• DSBLD—Traffic is disabled on the entity.
		• LPBK—Port or connection has a loopback on it.
		• FLT—Fault secondary state. When an entity is faulted, an FLT state is raised.
			Equipment and ports in FLT state should be cleared as they transition. Transition
			states are listed in Table 11-10 on page 11-15.
		See Table 11-10 on page 11-15for the Service state/Secondary state possible values.
		Note If the NE release does not support the Service state, this field shows N/A.
SF BER		Sets the signal fail bit error rate.
SD BER		Sets the signal degrade bit error rate.
Provide Sync		If checked, the card is provisioned as an NE timing reference.
EnableSyncMsg		When checked, enables synchronization status messages, which allow the node to choose
		the best timing source.
Send Do Not Use		When checked, sends a do not use (DUS) message on the S1 byte.
BLSR Ext. Byte		Select an alternate BLSR byte.
Type		Defines the port.
AINS Soak (H:M)		Automatic in-service soak. The determination of duration left before the
		traffic/termination transitions to IS state.
AINS Soak Count Down (H:M)		Automatic in-service soak countdown. Displays the remaining time of valid input signal
		in hh:mm, after which the card becomes in service (IS) automatically.

	Cisco Transport Manager Release 7.2 User Guide
D-44	78-17630-01