Ricoh AP2610N setup guide Error & Status Messages on the Control Panel

5. Troubleshooting

Error & Status Messages on the Control Panel

Messages/Second messages	Description	Solution
Call Service: EC	An error has occurred in the	First, turn the power switch
Power Off On	printer.	off and then on. If the message
		appears again, call your sales
/If Error Reoccur
		or service representative.
Call Service
Change Setting	The paper type and size set-	Load { paper size and type }
Tray #	ting on the tray differs from	paper with the selected feed
	the setting on the driver.	direction into tray. Printing
/Paper Size:
		will not automatically resume
Paper Type:
		if the paper type, size and di-
		rection setting is incorrect.
		Make sure that the paper size,
		feed directions and paper type
		set in the printer driver and on
		the control panel are the same.
		There are two methods to
		resume printing.
		A Use the control panel to set
		the correct paper type, size
		and direction of the paper
		in tray.
		B Press {Form Feed} and se-
		lect the tray with the con-
		trol panel.
		You can make to setting to
		print disregarding the error
		message.

		Reference
		See “Ppr.Size Error” in
		p.115 “Maintenance Menu
		Parameters”.
Cannot Check	The signal strength for the	Change the Transmission
Signal in Ad hoc	wireless LAN cannot be	mode to [Infrastructure] in the
	checked because "Ad hoc" is	Host Interface settings.
	selected in "Comm.Mode" for
	"IEEE 802.11b" in the Host In-
	terface menu.
Close Duplex	The cover of the optional Du-	Close the cover of the optional
Unit Cover	plex Unit is open.	Duplex Unit.

61