Ricoh AP2610N setup guide Comm.Mode, Channel, Trans. Speed, WEP Settings, 134

6

Making Printer Settings with the Control Panel

Menu	Description
IEEE 802.11b *2	You can make settings for using the wireless LAN. This menu ap-
	pears only when the optional IEEE 802.11b board is installed.

❖ Comm.Mode

You can set the transmission mode for IEEE 802.11b.

Note

❒ Default: Ad hoc

❖Channel

The selectable channels are 1-11 (Inch version) and 1-13 (Met- ric version).

Note

❒ Default: 11

❖Trans. Speed

You can set the transmission speed for IEEE 802.11b.

Note

❒ Default: Auto

❖WEP Settings

You can set the code for IEEE 802.11b.

	Note
	❒ Default: Not Active
	❒ You need to set the WEP code key from the network before
	making this setting. Without the key, transmission cannot
	be performed.
	❒ Be sure to set the key before setting the code to "Active".
USB Setting *3	You can set the transmission speed for USB.

	Note
	❒ Default: Auto
*1	Appears only when the 1394 Interface Unit board is installed.
*2	Appears only when the 802.11b Interface Unit board is installed.
*3	While the printer is Online, press {Enter #}, and then press {Escape}. Finally, press
	{Menu} . You can access the "USB Setting" menu on the panel display.

134