Ricoh AP2610N Ieee 1394 Configuration, Host Interface Ieee 1394 Setup, Ieee 1394 Setup IP over

IEEE 1394 Configuration

IEEE 1394 Configuration

Use this procedure to configure the printer for use in the IEEE 1394 envi- ronment. The following table shows the control panel settings and their default values. These items are in- cluded in the "Host Interface" menu.

Setting Name	Value
IP Address1394	000.000.000.000
Subnet Mask1394	000.000.000.000
IP over 1394	Active
SCSI print	Active
Bidi-SCSI print	Active

Depending on the protocol you use, procedures vary. See the following ta- ble.

IP over 1394	Steps A-Hand then
	go to steps M to N
SCSI print	Steps A-Dand then
	go to steps I to N
A Press {Menu}.

On Line	Menu
Job Reset	Escape
Form Feed	Enter
Power	Error	Data In
		ZFDP020N

“Menu” appears on the panel dis- play.

B Press {U} or {T} to display “Host Interface” menu.

Menu:

Host Interface

C Press {Enter #}.

On Line	Menu
Job Reset	Escape
Form Feed	Enter
Power	Error	Data In

ZFDP060N

The following message appears on the panel display.

Host Interface:

I/O Buffer

D Press {U} or {T} to display “IEEE 1394 Setup”.

Host Interface:

IEEE 1394 Setup

E Press {Enter #}.

The following message appears on the panel display.

IEEE 1394 Setup:

IP Address1394

F Press {U} or {T} to display “IP over 1394”.

IEEE 1394 Setup:

IP over 1394

APress {Enter #}.

BPress {U} or {T} to select ei- ther "Active" or "Not Active".

CPress {Enter #}.

The display returns to the previ- ous menu in a few seconds.

3

45