UNIX Configuration

Confirming the IP address

Follow the procedure below to confirm that the IP address has been configured correctly.

 

 

1

• Following procedure uses sample IP address: 192.168.15.16.

AEnter the following:

# ping 192.168.15.16

If the address has been configured correctly, the following message appears.

192.168.15.16 is alive

If the address has been configured incorrectly, the following message ap- pears.

no answer from 192.168.15.16

Note

When you use NIS, the IP address and host name are written to /etc/hosts on the master server. When you use DNS, the information is written to a data file on the name server. After writing the host name and IP address to the file, confirm the configuration by pinging the host name.

# ping host_name

If the host name is registered with an IP address, the server can access the printer using its host name instead of its IP address.

Executing the Installation Shell Script

After having configured the printer IP address, follow the procedure below to execute the installation shell script and set up the workstation printing environ- ment.

Preparation

Before executing the installation shell script, the IP address, the host name and the printer name must be required.

Following procedures use sample IP address: 192.168.15.16, sample host

name: nphost and sample printer name: np.

Note

Use ftp to get the installation shell script from the printer.

ALog on to the workstation as root.

Note

If you do not log on as root, the installation shell script will not run.

2

Page 454
Image 454
Ricoh AP2610N setup guide Executing the Installation Shell Script, Confirming the IP address, AEnter the following