Ricoh AP2610N setup guide Push the bottom plate down until it locks into place

Paper and Other Media

D Push the bottom plate down until it locks into place.

3

ZDDP360E

E Load envelopes into the Envelope Feeder Unit, with the print side down and the flap on the left as shown in the illustration.

ZDDP380E

Important

❒Confirm that the envelope flaps are securely folded down, and that there is no air inside the en- velopes.

Note

❒Confirm that the top of the stack is not higher than the limit mark on the side guides.

❒Confirm that the envelopes fit under the side guides.

❒Do not push the stack of enve- lopes with too much force.

F While pinching the side guides, slide them along the edge of the envelope stack.

ZGDY370E

G While pinching the rear guide, slide it along the edge of the enve- lope stack.

ZGDY390E

H While lifting the front of the tray, place it into the printer. Then slide it until it stops.

Important

❒Do not slide the paper tray in with force. If you do, the front and side guides might move.

48