Ricoh AP2610N setup guide Attach the 802.11b Interface Unit

Installing Options

G Place the controller board on a flat surface.

H Use a coin to remove the two screws, and then remove the cov- er.

2	Note
	❒ These screws are used again in

step J.

ZGDX410J

I Attach the 802.11b Interface Unit.

Insert the end of the 802.11b Inter- face Unit into the opening (A), and then push down until it clicks (B).

ZGDX420J

ZGDX431J

J Fasten the 802.11b Interface Unit to the controller board with the two screws.

ZGDX442J

K Insert the card slowly into the 802.11b board with the label fac- ing down and the uneven black antenna surface facing up until it stops.

ZGDX500J

L Match the controller board to the top and bottom rail using the "T" mark, and then slide it into the printer slowly until it stops.

ZGDX251J

30