Ricoh AP2610N setup guide If the Duplex Unit is not at- tached, go to step N

Memory Unit TypeB 64MB

G Place the controller board on a flat surface.

H Insert the Memory unit to the slot by placing the notch of the unit to the projection of the slot, and then push it down until it clicks.

ZGDX130J

K Fasten the controller board to the printer with the two screws.

2

ZGDX270J

Note

❒If the Duplex Unit is not at- tached, go to step N.

I Match the controller board to the top and bottom rail using the "T" mark, and then slide it into the printer slowly until it stops.

ZGDX250J

J Push the handle of the controller board until it clicks.

L While aligning the power cord to the left side groove of the Duplex Unit, slide the Duplex Unit in un- til it is connected to the printer.

ZGDX240J

M Attach the interface cable to the printer.

ZGDX380J

19