Ricoh AP2610N setup guide Messages/Second messages Description Solution

Troubleshooting

	Messages/Second messages	Description	Solution
	Replace	The toner cartridge is not set	Set the toner cartridge correct-
	Toner Cartridge	correctly or toner is almost	ly. See p.90 “Replacing the
		run out.	Toner Cartridge”.
		The toner dust is full.	Prepare a new toner cartridge.
			If the image density gets too
			light, replace the toner car-
			tridge with a new one. See
			p.90 “Replacing the Toner
			Cartridge”.
	Reset Fusing	The fusing unit is not set cor-	Set the fusing unit correctly,
	Unit Correctly	rectly.	or set the proper fusing unit.
	Reset Toner	The toner cartridge is not set	Set the toner cartridge correct-
	Cartridge	correctly.	ly. See p.90 “Replacing the
			Toner Cartridge”.
		The toner cartridge is not set	If the cartridge is installed,
		installed.	close the front cover and turn
5
			the off power switch and then
			on. If the message appears
			again, contact your sales or
			service representative.
	Reset Tray #	The input paper tray is not set	Set the input paper tray cor-
	Correctly	correctly.	rectly.
	Resetting Job...	The print job is being reset.	Wait for a while.
	SC XXX-X	An error has occurred.	First, turn the power switch
	Power Off On		off and then on. If the message
			appears again, call your sales
	If Error Reoccur
			or service representative.
	Call Service
	SC2001	An error has occurred in the	First, turn the power switch
		resident font RAM.	off and then on. If the message
			appears again, call your sales
			or service representative.
	Toner Is Almost	The toner is almost run out.	Prepare a new toner cartridge.
	Empty		If the image density gets too
			light, replace the toner car-
			tridge with a new one. See
			p.90 “Replacing the Toner
			Cartridge”.
	Waiting...	The printer is waiting for the	Wait for a while.
		next print job.
	Warming Up...	The printer is warming up or	Wait until the panel display
		toner is being supplied.	change the "Ready".

68