Ricoh AP2610N setup guide Setting Ssid, Setting the WEP Key, Using WEP, Applying the Settings

Appendix

Setting SSID

A Click [IEEE 802.11b].

B Enter a value in [SSID].

Important

❒If you cannot connect after mak- ing SSID and WEP key settings, select "WL.LAN Defaults" from the control panel, and then set IEEE 802.11b (wireless LAN) from the beginning. For more information about how to use the control panel, see the Setup Guide.

Note

❒The character strings to be set are in the range ASCII 0x20- 0x7e and the SSID is case-sensi- tive to 32 bytes.

	If using the WEP key, see p.90 “Set-
	ting the WEP Key”.
7
	If not using the WEP key, seep.90
	“Applying the Settings”.
	Setting the WEP Key
	A Click [IEEE 802.11b].
	B Enter a value in [WEPKey].

Note

❒You can set only 10 hexadecimal character strings.

C Change to enable use of WEP.

See p.90 “Using WEP”.

Using WEP

Important

❒To enable the WEP key, be sure to first enter a value for the WEP key. Seep.90 “Setting the WEP Key”.

❒With some products, depending on the access point or IEEE 802.11b card in use, it is possible to set more than one WEP key. In this case, make the first key the same as the WEP key set in the printer.

A Click [IEEE 802.11b].

B Change [Encryption] to [Enable]. C Apply all the settings.

See p.90 “Applying the Settings”.

Important

❒If you cannot connect after mak- ing SSID and WEP key settings, select "WL.LAN Defaults", and then make setting for IEEE 802.11b (wireless LAN) from the beginning. For more infor- mation about how to use the control panel, see the Setup Guide.

Applying the Settings

A Click [Refresh] or [Reload].

The settings are transmitted.

Note

❒To verify the settings, click [Con- fig Reference], and then click

[IEEE 802.11b].

B Exit the Web browser.

90