Troubleshooting

Cleaning the Paper Feed

Roller

If the paper feed roller is dirty, a mis- feed might occur. In this case, clean the roller as follows:

RCAUTION:

When lifting the printer, use the grips on both sides of the printer, otherwise the printer might fall and cause personal injury.

When you move the printer, un- plug the power cord from the wall outlet to avoid a fire or an electric shock.

5

When you pull out the plug from

 

the socket, grip the plug to avoid

 

damaging the cord and causing

 

a fire or an electric shock.

Important

The following are examples of cleaning the paper feed roller on the paper tray.

You can clean the paper feed roller on the optional Paper Feed Unit by following the procedures below. The paper feed roller on the op- tional Paper Feed Unit differs from the one on the paper tray. Confirm the type of paper feed roller you are installing.

For the paper tray

For the Paper Feed Unit

 

 

ZCEM200E

A Turn off the power switch.

B Pull out the plug from the socket. Remove all the cables from the printer.

C Lift the paper tray slightly then pull it out until it stops, and while lifting the front side of the tray, pull it out of the printer.

ZCEY140J

D Move the printer to the edge of a stable table or desk.

ZGDM110J

Important

Do not put the printer on an un- stable or tilted surface.

If the printer is equipped with the optional Paper Feed Unit, do not move the printer and unit together as they are not se- curely attached.

When lifting the printer, con- firm that the optional Paper Feed Unit is not attached to the printer.

94

Page 196
Image 196
Ricoh AP2610N setup guide Cleaning the Paper Feed Roller, Move the printer to the edge of a stable table or desk