Ricoh AP2610N setup guide Quick Installation GUIDEG074-8627

QUICK INSTALLATION GUIDE<G074-8627>

Please read the Safety Information in the Setup Guide or Printer Reference before using this machine. It contains important information related to USER SAFETY and PREVENTING MACHINE PROBLEMS.

WHERE TO PUT THE PRINTER

The printer’s location should be carefully chosen because environmental conditions greatly affect its performance.

Warning

∙Confirm that the wall outlet is near the machine and freely accessible, so that in event of an emergency, it can be unplugged easily.

∙Only connect the machine to the power source described on this sheet.

∙Avoid multi-wiring.

∙Do not damage, break or make any modifica- tions to the power cord. Do not place heavy ob- jects on it, pull it hard or bend it more than nec- essary. These actions could cause an electric shock or fire.

Caution

∙Keep the machine away from humidity and dust. A fire or an electric shock might occur.

∙Place the machine on a strong and level sur- face. Otherwise, the machine might fall and cause personal injury.

∙If you use the machine in a confined space, con- firm that there is a continuous flow of air.

Power Connection

Connect the power cord to a power source with the follow- ing specifications:

❒120V, 60Hz, 8.4A or more

Space Required for Installing the Printer

Leave enough space around the printer. This space is neces- sary to operate the printer. The recommended (or minimum) space requirement is as follows:

ZDDH010E

A:more than 10 cm (4.0")

B:more than 10 cm (4.0")

C:more than 100 cm (40.0")

D:more than 10 cm (4.0")

UNPACKINGTHE PRINTER AND CHECKINGTHE CONTENTS OF THE BOX

Check the contents of the box according to the following list. If one or some items are miss- ing, please contact your sales or service rep- resentative.

Important

❒The interface cable is not included in the box. Make sure that the interface cable you use is appropriate for your computer.

Quick Installation Guide (this sheet)

Setup Guide

CD-ROM (3)

Printer (including a starter toner cartridge)

Additional Documentation

Remove the plastic bag. Lift the printer and move it to the place where you want to install it.

When lifting the machine, use the inset grips on both sides. Otherwise

INSTALLING THE TONER CARTRIDGE

Warning

∙Do not incinerate spilled toner or used toner.Toner dust might ignite when exposed to an open flame.

∙Disposal can take place at our authorized dealer or at appropriate collection sites.

∙If you dispose of the used toner cartridge your- self, dispose of them according to your local regu- lations.

Caution

∙Do not eat or swallow toner.

∙Keep toner (used or unused) and the toner car- tridge out of reach of children.

∙Our products are engineered to meet the highest standards of quality and functionality. When pur- chasing expendable supplies, we recommend using only those provided by an authorized dealer.

Important

❒Do not expose the toner cartridge to a light for a long time. If you do, the toner cartridge will be damaged and the print quality might be reduced.

Open the front cover by pushing the front cover

Place the toner cartridge on a flat surface. Pull out the tape inside the unit horizontally while holding the cartridge with one hand as shown in the illustration.

Important

❒ Be sure to remove the tape completely before installing

the toner cartridge. Otherwise, the printer might be

damaged.

❒ If you pull out the strips when the toner cartridge

is slant or standing on its side, the cartridge might

cause trouble with the printer.

❒ Be sure to pull the tape horizontally. Pulling it

upward or downward may cause the toner to scatter.

❒ Be careful not to make your cloths dirty with toner.

❒ After pulling the tape out of the cartridge, toner scatters

INSTALLINGTHE PAPERTRAY

The default paper settings size are as follows: Metric version: A4 L (long-edge feed) Inch version: 81/2" x 11" L (long-edge feed)

For settings other than the default paper size, see “Loading Paper and Other Media” in the Printer Reference provided as a PDF file on the CD-ROM labeled "Operating Instructions".

For more information about the paper sizes that can be set in the paper tray, see “Paper and Other Media Supported by this Printer” in the Printer Reference provided as a PDF file on the CD-ROM labeled "Operating Instructions".

Lift the paper tray slightly then pull it out until it stops.

Optimum Environmental Conditions

Recommended temperature and humidity

%RH	10°C 80%		27°C 80%
80
	15°C		25°C	32°C
	70%		70%
60					54%
40	15°C		25°C
	30%		30%
20	10°C 15%		32°C 15%
10		20	30		°C
%RH	50°F 80%		80.6°F 80%
80	59°F		77°F
	70%		70%
60					89.6°F
					54%
40	59°F		77°F
	30%		30%
20	50°F 15%		89.6°F 15%
50	60	70	80	90	°F

Possible operation range Recommended range The machine must be level within 5 mm, 0.2" both front to rear and left to right.

Environments to Avoid

Important

the machine could break or cause injury if dropped.

ZGDT052N

Remove the orange adhesive tape (7 pieces).

release button.

ZGDH126E

Remove the fixing material inserted between toner cartridge and the printer.

ZGDT146E

While lifting the front side of the toner cartridge, pull it out of the printer.

easily. Do not shake the cartridge.

Holding the grips of the toner cartridge, insert it into the printer until it stops.

ZGDT121E

Insert the toner cartridge in its appropriate position by gently pushing down.

ZGDT145E

Close the front cover.

❒Do not touch the three white pins on the left front side of the printer.

While lifting the front side of the tray, pull it out of the printer.

Load paper into the paper tray with the print side up.

❒Locations exposed to direct sunlight or strong light

❒Dusty areas

❒Areas with corrosive gases

❒Areas excessively cold, hot, or humid

❒Locations near an air conditioner or humidifier

❒Locations near other electronic equipment

❒Locations where the printer might be subjected to frequent strong vibration

ZGDT115E

Note

❒Do not hold the toner cartridge upside down or stand it vertically.

❒Do not put the toner cartridge on an unstable or tilted surface.

ZGDH135E

Important

❒Do not close the front cover with force. If you cannot close the cover easily, pull out the toner cartridge from the printer and insert it again. After that, close the front cover again.

❒Confirm that the top of the stack is not higher than the limit mark inside the tray.

❒Confirm that the paper fits under the rear guide.