NetWare 4.x, 5/5.1 - Advanced Settings

Setting Up as a Remote Printer

A Log on to the file server as an Admin or an Admin equivalent. B Run the NIB Setup Tool.

Reference

See p.50 “Running the NIB Setup Tool” .

C Click [Property Sheet] and click [OK].

The [NIB Setup Tool - Network board list] dialog box of the Network Interface Board appears.

D Click [IPX protocol].

E Click the IPX address of the Network Interface Board which is to be config- ured, and then click [Next >].

Note

5

If you do not know which Network Interface Board you are configuring, see the network configuration page to check the MAC address (Network Address).

F Make sure that the MAC address and IPX address are correct, and then click [Finish].

The [NIB Setup Tool] window appears.

G Click [Configure].

The property sheet appears.

H Click the [General] tab, and then type the name of the print server into the [Device Name] box.

I Click the [NetWare] tab, and then make the following settings.

A In the [Print Server Name:] box, type the name of the print server.

B In the [File Server Name:] box, type the name of the file server in which a print server is to be created.

Clicking [Browse], you can select a file server among those listed in the [Browse] dialog box.

65

Page 355
Image 355
Ricoh AP2610N setup guide Setting Up as a Remote Printer