Ricoh AP2610N setup guide Ieee 802.11b Wireless LAN Configuration, Host Interface Ieee 802.11b

Configuring the Printer for the Network

IEEE 802.11b (Wireless LAN) Configuration

Configure the printer for using the wireless LAN. The following table shows the control panel settings and their default values. These items are included in the "Host Interface" menu.

Setting Name Value

3	Comm. Mode	Ad hoc
	Channel	•	Inch version
			(1-11) 11
		•	Metric version
			(1-13) 11
	Trans. Speed	Auto
	WEP Settings	Not Active

In order to use the wireless LAN, se- lect "IEEE 802.11b" for "LAN Type" in "Network Setup" of the Host Interface menu, and then set "IP Address", "Subnet Mask", "Gateway Address", "Network Boot", "Frame Type (NW)" and "Active Protocol" in the "Net- work Setup". For more information about setting the items in the "Net- work Setup", see p.41 “Ethernet Con- figuration”.

A Press {Menu}.

On Line	Menu
Job Reset	Escape
Form Feed	Enter
Power	Error	Data In

ZFDP020N

“Menu” appears on the panel dis- play.

B Press {U} or {T} to display “Host Interface” menu.

Menu:

Host Interface

C Press {Enter #}.

On Line	Menu
Job Reset	Escape
Form Feed	Enter
Power	Error	Data In

ZFDP060N

The following message appears on the panel display.

Host Interface:

I/O Buffer

D Press {U} or {T} to display "IEEE 802.11b".

Host Interface:

IEEE 802.11b

E Press {Enter #}.

Be sure that "Comm. Mode" ap- pears on the panel display.

IEEE 802.11b:

Comm. Mode

48