Ricoh AP2610N setup guide Configuring NetBEUI for Printing

Configuring the Protocols

B Configure the TCP/IP protocols with the appropriate IP address, subnet mask and other settings.

Check with the network administrator that the settings are correct.

C Click the [Services] tab, and then make sure that “Microsoft TCP/IP Print- ing” is installed.

If “Microsoft TCP/IP Printing” is not installed, click [Add] on the [Services ] tab, to install it. For more information about installing and configuring net- work services, see Windows NT Help.

Configuring NetBEUI for Printing

These instructions are for configuring the Network Interface Board and Win-	4
dows NT to use the NetBEUI protocol.

Preparation

To use NetBEUI, use the SmartNetMonitor for Client port.

Configuring the machine

Configure the machine to use the NetBEUI protocol.

•Make sure that the NetBEUI protocol is set to active. (The default is active.)

Reference

For more information about how to make the above settings, see the Setup Guide.

Configuring a Windows NT computer

Install the NetBEUI protocol on the Windows NT computer, and then change the LAN adapter number (Lana Number).

A Open [Control Panel], and then double-click the [Network] icon. Make sure that “NetBEUI Protocol” is listed in the [Network Protocols] box on the [Proto- cols] tab.

Note

❒If the NetBEUI protocol is not installed, click [Add] on the [Protocols] tab to install it. For more information about installing the NetBEUI protocol, see Windows NT Help.

B Change the Lana Number. Click the [Services] tab, click “NetBIOS Inter- face” in the [Services] tab, and then click [Properties].

C Click the Lana Number corresponding the Nbf protocol of the [Network Route] headline, and then click [Edit].

39