Windows 2000 Configuration

C Make sure that the“Internet Protocol (TCP/IP)” is selected in the [Compo- nents checked are used by this connection:] box on the [General] tab.

Note

Select the TCP/IP protocol box if it is not already selected.

If the TCP/IP protocol is not installed, click [Install] on the [General] tab to install it. For more information about installing the TCP/IP protocol, see

2

Windows 2000 Help.

D Configure the TCP/IP protocol with the appropriate IP address, subnet mask and other settings.

Check with the network administrator that the settings are correct.

Configuring NetBEUI for Printing

Follow these instructions to configure the Network Interface Board and Win- dows 2000 to use the NetBEUI protocol.

Preparation

To use NetBEUI, use the SmartNetMonitor for Client port.

Configuring the machine

Configure the machine to use the NetBEUI protocol.

Make sure that the NetBEUI protocol is set to active. (The default is active.)

Reference

For more information about how to make the above settings, see the Setup Guide.

Configuring a Windows 2000 computer

Follow these steps to configure a Windows 2000 computer to use the NetBEUI protocol.

A Click [Start] on the taskbar, point to [Settings], and then click [Network and Dial-up Connections].

B Click [Local Area Connection]. On the [General] tab, click [Properties].

C Make sure that the“NetBEUI Protocol” is selected in the [Components checked are used by this connection:] box on the [General] tab.

Note

Select the NetBEUI protocol box if it is not already selected.

If the NetBEUI protocol is not installed, click [Install] on the [General] tab and install it. For more information about installing the NetBEUI protocol, see Windows 2000 Help.

16

Page 306
Image 306
Ricoh AP2610N setup guide Configuring NetBEUI for Printing