Ricoh AP2610N setup guide Error & Status Messages on the Control Panel

Error & Status Messages on the Control Panel

Messages/Second messages	Description	Solution
HDD Full	The maximum HDD area size	Delete the disused form/font
	for form/font has been ex-	types.
	ceeded.
HDD Full	The optional Hard Disk Drive	Delete any unnecessary stored
	is full. The sample print job or	files.
	locked print job to be sent
	from the computer is too large
	to store.
HDD Not Installed	You cannot print the sample	Install the Hard Disk Drive.
	print and the locked print	See “Hard Disk Drive Type
	jobs, because the optional	2600” in the Setup Guide.
	Hard Disk Drive is not in-
	stalled.
Hex Dump Mode	The printer is in Hex Dump	Wait for a while. If the "Hex
	Mode.	Dump Mode" message does
		not change, on the panel dis-
		play press {On Line} to return
			5
		to the "Ready" condition.
I/O Buffer Overflow	There is too much data for the	Make sure the interface cable
	I/O buffer to handle.	is inserted into the printer and
		your computer securely.
		Make sure the interface cable
		is not damaged or broken.
		Increase the size of the I/O
		buffer.
Invalid Password	The password was not en-	Wait for two seconds until the
Try Again	tered correctly.	previous display appears.
		Then enter the password cor-
		rectly.
Load Correct	The paper size setting on the	Load { paper size } paper of
Size Paper	tray differs from that of actual	the selected feed direction and
	paper size in the tray.	paper size into the tray. Print-
/Press #
		ing will not automatically
to Continue
		resume if the paper size and
		direction setting is incorrect.
		Make sure that the paper feed
		directions set in the printer
		driver and on the control pan-
		el are the same. There are two
		methods to resume printing.
		A Use the control panel to set
		the correct paper size and
		direction of the paper in
		tray. Then press {Enter #}.
		B Press {Form Feed} and se-
		lect the tray with the con-
		trol panel.

65