Ricoh AP2610N setup guide Replacing the Friction Pad, Preparing to replace the parts, 145

Replacing Parts

Preparing to replace the parts

You should replace all the parts included in Maintenance Kit at the same time. Be sure to replace them in the following order:

A Check the contents of the box for the following items:

•Friction pad for the paper tray (Tray 1)

•Friction pad for the Paper Feed Unit (Tray 2, 3)

•Paper feed roller for the paper tray (Tray 1)

•Paper feed roller for the Paper Feed Unit (Tray 2, 3)

•Transfer roller

•Fusing Unit

•Gloves

B Confirm that the followings are true:

•The power switch is turned off.

•The power cord is unplugged from the wall outlet.

•The interface cable is unplugged from the printer.

Replacing the Friction Pad

Replace all friction pad of the tray. There are two kinds of friction pads. One is for the paper tray (Tray 1), and the other are for the Paper Feed Unit(s) (Tray 2, 3). The following pro- cedure shows how to replacing fric- tion pad of the paper tray (Tray1).

A If the optional Duplex Unit, the Mailbox or the 1–bin Shift Sort Tray are installed, uninstall them from the printer.

B Lift the paper tray slightly then pull it out until it stops.

ZCEY430J

C While lifting the front side of the tray, pull it out of the printer.

7

ZCEY140J

D Remove paper from the paper tray. Place the tray upside down on a flat surface.

ZCEM160J 145