Ricoh AP2610N Configuring Protocols, Configuring TCP/IP and IPP for Printing, Command Prompt

Windows 95/98/Me Configuration

Configuring Protocols

1Configuring TCP/IP and IPP for Printing

These instructions are for configuring the Network Interface Board and Win- dows 95/98/Me to use the TCP/IP protocol and IPP.

Configuring the machine

Configure the machine to use the TCP/IP protocol.

•Make sure that the TCP/IP protocol is set to active. (The default is active.)

•Assign an IP address and make other settings required for using the TCP/IP protocol.

Reference

For more information about how to make the above settings, see the Setup Guide.

If DHCP is used to assign IP addresses, see p.121 “Using DHCP”.

Note

❒After setting the IP address, use the ping command to make sure that it has been set correctly.

A Enable the use of the command prompt as follows:

•On Windows 95 or Windows 98

Click [Start], point to [Programs], and then click [Command Prompt].

•On Windows Me

Click [Start], point to [Programs], point to [Accessories], and then click

[Command Prompt].

BType the following: (Example IP address is 192.168.15.16)

C:\> ping 192.168.15.16

If the address has been configured correctly, the following message ap- pears.

Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32

If the address has been configured incorrectly, the following message ap- pears.

Request timed out.

2