Ricoh AP2610N setup guide ERS\ UTILITY\1394

5

Troubleshooting

Possible Cause		Solutions
Do you print via a net-	Confirm that the "Ethernet" setting is correct from the control pan-
work?	el. See p.130 “Host Interface Menu”.
	The setting governs the data transfer speed used by the Network
	Interface Board. Three options are available:
	•	Auto (default)
	•	100 Mbps
	•	10 Mbps

	Note
	❒ For more information about the appropriate setting to use on
	your network, contact your network administrator.
If you use IEEE 1394, check A Make sure the 1394 Interface Unit is installed properly.
for the followings.	B Make sure the IEEE 1394 cable is connected properly.
	C Restart the computer.
	If the problem still exists when SCSI print is used with Win-
	dows 2000 and Windows XP, go to step D.
	D Disconnect all the IEEE 1394 cables from the computer.
	E If you uninstall the printer driver when the printer is connect-
	ed to a computer with "SCSI print", the printer driver may not
	be uninstalled properly. To uninstall the driver properly, use
	the IEEE 1394 Printer Removal Utility on the CD-ROM that
	comes with the printer.
	Stored in: CD-ROM labeled "Operating Instructions"\DRIV-
	ERS\ UTILITY\1394\

	Note
	❒ For more information about the IEEE 1394 Printer Removal
	Utility, see the README file in the same folder as the pro-
	gram.
	F Restart the computer.
How is the signal strength	Check the signal strength from the Maintenance menu. If the sig-
when using the wireless	nal is weak, move to a place with better signal strength or remove
LAN?	objects that are possibly interfering with data transmission.
	The signal strength appears only in infrastructure mode. If you are
	using the ad hoc mode, the signal strength does not appear on the
	control panel. For more information about displaying the signal
	strength, see p.120 “Displaying the Signal Strength”.

Note

❒If you cannot solve the problem by taking the preceding actions, contact your sales or service representative.

78