Installing Options

E Pull out the handle of the control- ler board.

2

ZGDX370J

F Pull the handle and slide the con- troller board out.

ZGDX261J

G Place the controller board on a flat surface.

H Use a coin to remove the two screws, and then remove the cover.

Note

These screws are used again in step J.

The removed cover is not used when installing the Network In- terface Board.

22

ZGDX410J

I Insert the end of the Network In- terface Board into the opening (A), and then push down until it clicks (B).

ZGDX422J

ZGDX432J

J Fasten the Network Interface Board to the controller board.

ZGDX441J

Page 36
Image 36
Ricoh AP2610N Pull out the handle of the control- ler board, Fasten the Network Interface Board to the controller board