Ricoh AP2610N setup guide Setting Ieee 802.11b, Ieee 802.11b settings are displayed

Appendix

SLP

Use this command to configure SLP settings.

You can search the NetWare server using SLP in the PureIP environment of NetWare5/5.1. To use the slp command, you can configure the value of TTL which can be used by the SLP multi-cast-packet.

Note

❒The default value of TTL is “1”. A search is executed only within a local seg- ment. If the router does not support multi-cast, the settings are not available even if the TTL value is increased.

❒The acceptable TTL value is 1 - 255. msh> slp ttl {1 - 255}

Setting IEEE 802.11b

To make setting for IEEE 802.11b, use the wiconfig command.

Limitation

❒You can make settings when installing the optional 802.11b Interface Unit.

	❖ View settings
7	The IEEE 802.11b settings are displayed.
	msh> wiconfig

The IEEE 802.11b card information is displayed.

msh> wiconfig cardinfo

Note

❒If the IEEE 802.11b interface is not working correctly, the IEEE 802.11b card information is not displayed.

❖Configuration

Parameter	Value to be configured
mode [apadhoc]	You can set infrastructure mode (ap) or ad
	hoc mode (adhoc).
	The default is ad hoc mode.
ssid ID value	You can set for SSID in infrastructure mode.
	The characters that can be used are ASCII
	0x20-0x7e (32 bytes).
	A SSID value is set automatically to the near-
	est access point if the setting has not been
	made.
	If the setting has not been made for ad hoc
	mode, the same value as for infrastructure
	mode or an "ASSID" value is set automatical-
	ly if the setting has not been made.

102