Ricoh AP2610N setup guide NDS Context box, type the context of the print server

The property sheet appears.

NetWare Configuration

E Click the IP address of the Network Interface Board which is to be config- ured, and then click [Next >].

Note

❒If you do not know which Network Interface Board you are configuring, see the network configuration page to check the MAC address (Network Address).

F Make sure that the MAC address and IP address are correct, and then click [Finish].

The [NIB Setup Tool] window appears.

G Click [Configure].

H Click the [General] tab, and then type the name of the print server into the [Device Name:] box.

5I Click the [NetWare] tab, and then make the following settings.

A In the [Print Server Name:] box, type the name of the print server.

B In the [File Server Name:] box, type the name of the file server in which a print server is to be created.

Clicking [Browse], you can select a file server among those listed in the [Browse File Server] dialog box.

C In the [NDS Context:] box, type the context of the print server.

Clicking [Browse], you can select an NDS tree and an NDS context among those listed in the [Browse Context] dialog box.

As a context, object names are typed from a lower object and divided by a period. For example, if you want to create a print server into NET under DS, type “NET.DS”.

DIn the [Print Server Operation Mode] group, click [As Print Server].

EClick [OK] to close the property sheet.

FAfter the confirmation dialog box appears, click [OK].

J On the [NIB] menu, click [Exit] to exit the NIB Setup Tool.

After this step, go to step K on p.61 “Setting Up as a Print Server”.

64