Ricoh AP2610N Configuring NetBEUI for Printing, Configuring a Windows 95/98/Me computer

Configuring Protocols

Configuring a Windows 95/98/Me computer

These steps are for configuring a Windows 95/98/Me computer to use the TCP/IP protocol.

A Open [Control Panel] and then double-click the [Network] icon. Make sure that 1 “TCP/IP” is listed in the [The following network components are installed:] box on

the [Configuration] tab.

Note

❒If the TCP/IP protocol is not installed, click [Add] on the [Configuration] tab to install it. For more information about installing the TCP/IP protocol, see Windows 95/98/Me Help.

B Configure the TCP/IP protocol with the appropriate IP address, subnet mask and other settings.

Check with the network administrator that the settings are correct.

Configuring NetBEUI for Printing

These instructions are for configuring the Network Interface Board and Win- dows 95/98/Me to use the NetBEUI protocol.

Preparation

To use NetBEUI, use the SmartNetMonitor for Client port.

Configuring the machine

Configure the machine to use the NetBEUI protocol.

•Make sure that the NetBEUI protocol is set to active. (The default is active.)

Reference

For more information about how to make the above settings, see the Setup Guide.

3