Ricoh AP2610N setup guide Using in Ad hoc Mode, LAN Type Ieee 802.11b

Appendix

Using in Ad hoc Mode

A Press {Menu}.

"Menu" appears on the panel dis- play.

B Press {U} or {T} to display "Host Interface", and then click {OK}.

Menu:

Host Interface

C Press {U} or {T} to display "Net- work Setup, and then click {OK}.

Host Interface:

Network Setup

The following is displayed when installing the 802.11b Interface Unit in the printer with Ethernet as standard equipment.

7 If the 802.11b Interface Unit has been installed in the printer with Ethernet as standard equipment, go to step F.

D Press {U} or {T} to display "LAN Type", and then click {OK}.

Network Setup:

LAN Type

E Press {U} or {T} to display "IEEE 802.11b ", and then click {OK}.

LAN Type:

IEEE 802.11b

F Make the network settings. The following items must be set:

•IP Address

•Subnet Mask

•Gateway Address

•Network Boot

•Frame Type (NW)

•Active Protocol

For more information about how to make the settings, see the Setup Guide.

G Make setting for the computer.

Set the transmission mode of the IEEE 802.11b card installed in the computer to ad hoc mode and the channel to 11. Make the computer network settings. The following items must be set:

•IP Address

•Subnet Mask

Reference

For more information about how to make setting for the IEEE 802.11b card installed in the computer and the computer in use, see the appropriate oper- ating instructions or consult your network administrator.

Note

❒Depending on the client soft- ware of the IEEE 802.11b card installed in the computer, the channels might not be able to be set. In this case, set the printer channel to the channel specified by the computer.

88