Ricoh AP2610N Setting Up as a Print Server, Click Property Sheet and click OK, Select Bindery

NetWare 3.x - Advanced Settings

Setting Up as a Print Server

A Log on to the file server as a Supervisor or a Supervisor equivalent. B Run the NIB Setup Tool.

Reference

See p.50 “Running the NIB Setup Tool” .

C Click [Property Sheet] and click [OK].

The [NIB Setup Tool - Network board list] dialog box of the Network Interface Board appears.

D Click [IPX protocol].

E Click the IPX address of the Network Interface Board which is to be config- ured, and then click [Next >].

Note

5

❒If you do not know which Network Interface Board you are configuring, see the network configuration page to check the MAC address (Network Address).

F Make sure that the MAC address and IPX address are correct, and then click [Finish].

The [NIB Setup Tool] window appears.

G Click [Configure].

The property sheet appears.

H Click the [General] tab, and then type the name of the print server into the [Device Name] box.

I Click the [NetWare] tab, and then make the following settings.

ASelect [Bindery].

BIn the [File Server Name:] box, type the name of the file server in which a print server is to be created.

Click [Browse] to select a file server among those listed in the [Browse] dia- log box.

CClick [OK] to close the property sheet.

DAfter the confirmation dialog box appears, click [OK].

J On the [NIB] menu, click [Exit] to exit the NIB Setup Tool. K Type “PCONSOLE” from the command prompt.

F:> PCONSOLE

55