Ricoh AP2610N setup guide Select Property Sheet, and then click OK, Click the NetBEUI tab

Appendix

E Select [Property Sheet], and then click [OK].

TCP/IP

A Click the [General] tab, and then type the device name into the [Device

Name] box and comment into the [Comment] box.

•In the [Device Name] box, type the name of the printer in under 13 char- acters. The factory default name consists of "RNP" and the last 3 bytes of the MAC address on the Network Interface Board. For example, when the MAC address is 00:00:74:62:7D:D5, the factory default name is "RNP627DD5". No name of 9 characters is permitted if the prefix is "RNP". Also, when DHCP is selected as an IP address setting, the number of characters is limited to 13 characters.

•In the [Comment] box, type any comment on printers in under 31 charac- ters.

NetBEUI

A Click the [General] tab, and then type the comment into the [Comment] box.

In the [Comment] box, type any comment on printers in under 31 characters.

7	B Click the [NetBEUI] tab.
	C Type the computer name into the [Computer Name] box.

•In the [Computer Name] box, type the name that helps you to identify printers using the NetBEUI protocol. The factory default name consists of "RNP" and the last 3 bytes of the MAC address on the Network Inter- face Board. For example, when the MAC address is 00:00:74:62:7D:D5, the factory default name is "RNP627DD5". A maximum of 13 characters consisting of uppercase English letters, numeric, or symbols (except "*+,/:;<=>?[\]. and space) can be used. No name is permitted if the prefix is "RNP". You must avoid the duplication of the same name on a network.

•In the [Comment] box, type any comment on printers in under 31 charac- ters.

F Click [OK].

The NIB Setup Tool exits, and the setting is transmitted to the printer.

G Exit SmartNetMonitor for Admin.

82