Ricoh AP2610N setup guide Configuring LPR Port Printing

Windows NT 4.0 Configuration

Configuring LPR Port Printing

This section explains the procedure for printing to a LPR port from Windows NT.

Note

❒The following procedure assumes that the printer drivers have already been installed. This is the procedure to change the printer port to LPR.

❒The TCP/IP protocols must be installed and configured correctly. For more information about configuring the protocol, see p.38 “Configuring TCP/IP and IPP for Printing”.

A Click [Start], point to [Settings], and then click [Printers].

4B Click the icon of the printer you want to use. On the [File] menu, click [Prop- erties].

C Click the [Ports] tab, and then click [Add Port].

D In the [Available Printer Ports] box, click “LPR Port”, and then click [New Port].

Note

❒If “LPR Port” does not appear, “Microsoft TCP/IP Printing” has not been installed.

E Type the IP address of the Network Interface Board into the [Name or address of server providing lpd] box.

F Type “lp” into the [Name of printer or print queue on that server] box, and then click [OK].

G Click [Close].

H Make sure that the port name is displayed in the [Print to the following port(s)] box and the check box is selected, and then click [OK].

46