Ricoh AP2610N setup guide Use a coin to remove the two screws

Installing Options

D Use a coin to remove the two screws.

Note

❒These screws are used again in step M.

2

ZGDX280J

E Pull out the handle of the control- ler board.

ZGDX370J

F Pull the handle and slide the con- troller board out.

ZGDX260J

G Place the controller board on a flat surface.

H Use a coin to remove the two screws, and then remove the cov- er.

Note

❒These screws are used again in step J.

ZGDX410J

I Attach the 1394 Interface Unit to the controller board.

Insert the end of the 1394 Interface Unit into the opening (A), and then push down until it clicks (B).

ZGDX421J

ZGDX430J

26