Ricoh AP2610N setup guide Job Spool, Key key value

		Remote Maintenance by telnet
Parameter	Value to be configured
channel frequency channel no.	You can set the channel.
	You can specify from following channel.
	•	Metric Version :1-13
	•	Inch Version :1-11
	Set the same channel for all the machines you
	are using.
enc [onoff]	You can enable or disable the WEP function.
	To enable the WEP function, specify [on]; to
	disable it, specify [off].
	To start the WEP function, enter the correct
	WEP key.
key [key value]	Only 10 hexadecimal characters can be used.
	To use this function, set the same WEP key
	for all the ports that transmit to each other.
auth [openshared]	You can set the authorized mode when using
	WEP. The specified value and the authorized
	mode are as follows:
	open: Open system authorized (default)
	shared: Shared key authorized
rate [auto11m5.5m2m1m]	You can set the IEEE 802.11b transmitting
	speed.
	The transmitting speed you specify here is		7
	the speed at which data is sent. You can re-
	ceive data at any speed.
	auto: automatically set (default)
	11m: 11 Mbps fixed
	5.5m: 5.5 Mbps fixed
	2m: 2 Mbps fixed
	1m: 1 Mbps fixed

Job Spool

Use this command to configure Job Spool settings.

Limitation

❒You can only specify the LPR and IPP protocol.

Note

❒This machine information cannot reload automatically when you confirm the Job spool settings on the Web browser. Click [Reload] or [Refresh] on the Web browser when you want to reload this machine information.

❖Reference

The job spool setting appears. msh> spoolsw

103