Ricoh AP2610N setup guide Click Browse, Click Open Click OK

Installing the Printer Driver Using IEEE 1394

Windows 2000

A Connect the printer and the computer using the IEEE 1394 interface cable.
B In the [Found New Hardware Wizard] dialog box, and then click [Next>].
C When the [This wizard will complete the installation for this Device: Unknown] mes-
sage appears, select [Optional search locations:], and then click [Next>].
D When the [Locate Driver Files] message appears, select the [Optional search loca-
tions.] check box, and then select [Specify a location], and then click [Next>].
E Hold down the left {SHIFT} key and insert the CD-ROM into the CD-ROM
drive.	4
Keep the left {SHIFT} key held down until the computer has finished access-
ing the CD-ROM.

If the Auto Run program starts, click [Cancel], and then [Exit].

F Click [Browse].

G Select the printer driver that you want to use. The following are locations where printer drivers are stored:

•RPCS \DRIVERS\RPCS\WIN2000\DISK1

•PCL6

\DRIVERS\PCL6\WIN2000\DISK1

•PCL5e

\DRIVERS\PCL5e\WIN2000\DISK1

•PostScript 3 \DRIVERS\PS3\WIN2000\DISK1

H Click [Open].

I Click [OK].

A printer model selection dialog box appears.

J Follow the instructions on the screen.

Note

❒During installation, the [Digital Signature Not Found] dialog box may appear. In this case, click [Yes] to continue the installation.

❒If the printer driver is already installed, the printer icon is automatically added to the [Printer] folder. In such a case, installation of the printer driver is not necessary.

❒When the installation is complete, "1394_00n" appears on the [Printers] connected.")

the printer with its port directed to folder. ("n" is the number of printers

69