Ricoh AP2610N Commands List, TCP/IP address, Reference, Interface name Interface to be configured

Remote Maintenance by telnet

❒When the Network Interface Board is reset, the active print job which has already been sent to the machine will finish printing. However, jobs that have not been sent yet will be canceled.

Commands List

Use this command to display remote maintenance use.

Note

❒Type “help” to see a list of commands that can be used. msh> help

❒Type “help command_name” to display information about the syntax of that command.

msh> help command_name

TCP/IP address

Use the ifconfig command to configure TCP/IP (IP address, subnet mask, broad- cast address, default gateway address) for the machine.

❖Reference

msh> ifconfig

❖ Configuration		7
	msh> ifconfig interface_name parameter address
	Interface name	Interface to be configured
	ether	Ethernet Interface *1
	naf0
	ip1394 *2	IEEE 1394 Interface
	fwip0 *2
	wlan *3	IEEE 802.11b Interface
	wi0 *3

*1

*2

*3

If you did not enter the interface name, it will be automatically set to the Ethernet interface.

Available when the 1394 Interface Unit Type 4510 is installed.

You can specify an interface when installing the optional 802.11b Interface Unit Type A.

Parameter	Meaning
(no parameter)	IP address
netmask	subnet mask
broadcast	broadcast address

93