Ricoh AP2610N setup guide Ethernet Configuration, Setting Name Value

3.Configuring the Printer for the Network

Make the network settings below depending on the network interface you use.

•Parallel/USB: Making network settings is not necessary. Go to p.51 “Install- ing the Printer Driver and Software”.

•Ethernet: Make the settings in p.41 “Ethernet Configuration”, and then see p.51 “Installing the Printer Driver and Software”.

•IEEE 1394: Make the settings in p.45 “IEEE 1394 Configuration”, and then see p.51 “Installing the Printer Driver and Software”.

•Wireless LAN: Make the settings in p.48 “IEEE 802.11b (Wireless LAN) Con- figuration”, and then see p.51 “Installing the Printer Driver and Software”.

Note

❒The optional Network Interface Board is necessary to use Ethernet with Basic model printer.

❒The optional 1394 Interface Unit is necessary to use IEEE 1394.

❒The optional 802.11b Interface Unit is necessary to use the wireless LAN.

Ethernet Configuration

Configure the printer for the network using the printer's control panel.

The following table shows the control panel settings and their default val- ues. These items are included in the ”Host Interface” menu.

Reference

For information about configuring the computer for the network, see the Network Printing Guide on the CD-ROM labeled “Operating In- structions”.

For information about “Host Inter- face” menu, see “Host Interface Menu” in the Printer Reference on the CD-ROM labeled “Operating Instructions”.

Setting Name	Value
IP Address	011.022.033.044
Subnet Mask	000.000.000.000
Gateway Address	000.000.000.000
Network Boot	None
Frame Type (NW)	Auto
(Frame type NetWare)
Active Protocol	TCP/IP	❍ *1
	NetWare	❍ *1
	NetBEUI	❍ *1
	AppleTalk	❍ *1
Ethernet *2	Auto
LAN Type *3	Ethernet

*1 ❍ means that this protocol is active.

*2 Make this setting only when it is nec- essary.

*3 Appears only when both the Network Interface Board and the 802.11b Inter- face Unit are installed.

41