Ricoh AP2610N setup guide Configuring a Wins Server, Using a WWW browser, Click Network Config

Appendix

Configuring a WINS Server

The printer can be configured to register its NetBIOS name with a WINS server when power is turned on. This enables the NetBIOS name of the printer to be specified from SmartNetMonitor for Admin even under a DHCP environment.

This section describes how to configure the WINS server.

Note

❒The WINS Server is supported with Windows NT 4.0 Server Service Pack 4 or later, and Windows 2000 Servers WINS Manager.

❒For more information about the WINS Server settings, see Windows Help.

❒If there is no reply from the WINS Server, the NetBIOS name will be regis- tered by broadcast.

❒The NetBIOS name consists of up to 13 alphanumeric characters.

Using a WWW browser

A Start the Web browser.

B Point your browser at the URL or IP address of the printer (e.g. ht- tp://XXX.XXX.XXX.XXX where the Xs are the number of the IP address).

7 The status of the printer you chose appears on the Web browser.

C Click Network Config.

The dialog box for entering the password and user name is displayed.

D Enter your user name and password, and then click OK.

To use the factory default account, enter no user name and type "password" for the password.

E Click TCP/IP.

F Set WINS to active and enter the IP address of the WINS server in Primary WINS Server and Secondary WINS Server.

G Click Refresh.

H Exit the Web browser.

122