Ricoh AP2610N setup guide Printer status, Protocol, Command Information that is displayed

Appendix

Protocol

Use the set command to allow/prevent remote access for each protocol.

msh> set protocol {up down}

Protocol
appletalk	“up” means active and “down” means
tcpip	inactive.
netware
netbeui
scsiprint *1
ip1394 *1
lpr
ftp
rsh
diprint
web
snmp
ipp

*1 Available when the 1394 Interface Unit Type 4510 is installed.

Note

7 ❒ If you prohibit remote access using TCP/IP and then log out, you cannot use remote access. If this was a mistake, you can use the control panel to allow ac- cess by TCP/IP.

❒When you prevent access via TCP/IP, you are also prevented from using ip1394, lpr, ftp, rsh, diprint, web, snmp and ipp.

Printer status

The following commands can be used to get information about the current status of the printer.

msh> command

Command	Information that is displayed
status	Status of printer.
	Information about the print jobs.
info	Information about the paper tray, output tray,
	printer language of printer.
prnlog [ID]	Lists the last 16 print jobs.

Note

❒More information about any print job is displayed when the ID number is added after the prnlog command.

96