Ricoh AP2610N Getting Printer Information over the Network, Printer current status, Telnet

Error & Status Messages on the Control Panel

Getting Printer Information over the Network

Printer current status

You can check the printer's status using the telnet command.

❖telnet

Use the status command.

❖UNIX

Use the lpq or lpstat command or stat parameter of rsh, rcp, or ftp.

Reference

For more information, see “Remote Maintenance by Telnet (mshell)” in the Network Printing Guide is provided on the CD-ROM labeled “Operating Instructions”.

Messages	Description	Comments
Call Service Center	There is a malfunction in the	Turn the printer off and on.
	printer.
Cover Open: Duplex Unit	The cover of the optional Du-	Close the cover of the optional
	plex Unit is open.	Duplex Unit.
Cover Open: Front Cover	Close the front cover.	Close the front cover.
Cover Open: Mailbox	The cover of the Mailbox is	Close the cover of the Mailbox
	open.	cover.
Cover Open: Paper Exit/Rear	The paper exit cover or the	Close the paper exit cover or
	rear cover is open.	the rear cover.
Cover Open: Upper Tray	The upper tray cover is open.	Close the upper tray cover.
Empty: Toner	The toner cartridge is empty.	Replace the new toner car-
		tridge.
Energy Saver Mode	The printer is in Energy Save	Wait for a while.
	Mode.
Energy Saver Mode 1
Error: HDD Board	An error has occurred in the	First, turn the power switch
	optional Hard Disk Drive.	off and then on. If the message
		appears again, call your sales
		or service representative.
IEEE 802.11b Card Error	The optional IEEE 802.11b	Install the optional IEEE
	board or the optional IEEE	802.11b board or the optional
	802.11b card is not installed.	IEEE 802.11b card.
IEEE 802.11b Card or Board	An error has occurred in the	First, turn the power switch
Error	optional IEEE 802.11b board	off and then on. If the message
	or the optional IEEE 802.11b	appears again, set the optional
	card	IEEE 802.11b board. If the
		message still appears, call
		your sales or service repre-
		sentative.

5

69