236 Chapter 27 Display prompts and messages
Display prompt
Conference busy
Conf Resrce Full
Denied in admin
Dial voice call
DND from NNN
DND transfer
DN: Idle
DRT Line001
Do not disturb
PRIORITY LATER
Do not disturb
CANCL RETRY JOIN
Enter code:
Enter digits
QUITOK
Enter zone:___
ALL
Exchanged
Expensive route
F__
QUIT CLEAR
Description of error or action
Conference: You tried to make a conference call, but your system is handling the maximum number of conference calls (six).
Silent Monitor: The six conference resources on the system are already occupied.
This is a transient display that reverts to HG Member DN: busy.
You are trying to use a feature, but do not have access to it under administration.
Last Number redial: The Last Number is not allowed.
Voice call: Dial the internal number or press the internal auto dial button of the person to whom you want to speak.
Prime telephone: The person at telephone NNN has forwarded a call to you using Do Not Disturb.
Prime telephone: The system has transferred a call to you from a telephone with Do Not Disturb activated.
Silent monitor: The current call on the telephone you are monitoring is either not a
Hunt Group call, or the call came in on a line key on that telephone. Note: Lines that are assigned to the hunt group must not be assigned to individual hunt group members.
Prime telephone: No person answered this call, so the system transferred it to you.
The telephone you are calling has Do Not Disturb turned on. Press LATER to use the Ring Again or Messages features, or press PRIORITY to make a priority call.
Priority Call: The telephone to which you want to transfer the call has Do Not Disturb active.
Transfer: The person to whom you tried to transfer a call has Do Not Disturb active on their telephone.
•Press JOIN to transfer the call.
•Press RETRY to transfer the call to another person.
•Press CANCL or the flashing line button to reconnect to the call.
•On 7000 and 7100 digital phones use feature code FEATURE #70 to cancel the call.
Feature button: If you are checking a speed dial button, enter the
Auto dial: Enter the number you want to program, selecting the line first, if necessary, exactly as if you were placing a call.
Speed dial: Enter the telephone number you want to program exactly as if you were dialing it normally. When you are finished, press HOLD or OK.
Page: Enter the required page zone number (0- 6) or press ALL.
Move button: The two buttons you selected have exchanged position.
You have dialed a number, but the least expensive route programmed for the system is busy. Unless you release the call, the number goes through on a more expensive route.
Feature button: Enter the feature code, or press RLS or QUIT to end programming or CLEAR to clear the numbers entered. The system accepts the entry when you enter a valid feature code.
