242 Chapter 27 Display prompts and messages
Display prompt
Pick up receiver
Please wait
Pool code: ___
QUIT
Press a button
QUIT
Press a line
Press held line
Program and HOLD
Program and OK
QUITOK
Programmed
Priority> NNN
BLOCK
Priority denied
Redir by NNN
OVERRIDE
Redirect denied
Release a call
Description of error or action
You have used the Call Queuing feature without lifting the handset. Auto Handsfree is not assigned to your telephone. You must use the handset, or press the handsfree button to answer a call.
Priority call: The party you are calling has eight seconds to decide to accept or reject your priority call.
Line redirection: Enter a valid line pool access code.
Auto dial: Press the memory button you want to program.
Button inquiry: Press the button you want to check. Press FEATURE or EXIT when finished.
Move button: The button you are trying to move is not a line button. If you are trying to switch a line and a feature, move the line to the feature button, not the feature button to the line.
Conference call: You have activated the Conference feature with one call active and another on hold. Press the held line to bring that person into the conference.
Auto dial: Enter the number you want to program on the button, then press HOLD.
Speed dial: If you want to program a line or line pool selection for this speed dial number, select the line or line pool. If not, enter the telephone number exactly as if you were dialing it normally. When you are finished, press HOLD.
Enter the number you want to program on the button, then press HOLD or OK. You can include a line or line pool selection in an auto dial sequence by selecting the line before entering any digits.
Speed dial: If you want to program a line or line pool selection for this speed dial number, select the line or line pool. If not, enter the telephone number you want to program exactly as if you were dialing it normally. When you are finished, press OK.
The number is stored correctly on the button.
You are receiving a priority call. If you are on another call, tell the person to whom you are speaking, that you are about to place the call on hold. Press the flashing line indicator of the priority call, or wait until the call connects automatically (in eight seconds). The priority call goes through after you hear the next beep. Your active call is on Exclusive Hold. It reconnects automatically when the priority call ends (unless
you transfer the priority call, in which case, you must press the line button of your original call to reconnect). Use DND (FEATURE 85) or press BLOCK to reject a
priority call.
Priority call: The telephone you are calling is receiving a priority call at the same time, or cannot receive priority calls.
Line redirection: You have tried to redirect a line, but another person has redirected that line. Press * or OVERRIDE to override the previous redirection and redirect the line.
Line redirection: You can redirect calls only on individual lines.
You have no free line available to receive a call. Release one of your current calls, and try again to answer the incoming call.
