Nortel Networks N0060600 manual Configuring a new time zone on a remote IP telephone

146Chapter 20 Global VoIP features

4Enter the DN of the telephone you want to divert to this telephone.

Note: If the originating telephone does not allow Hot desking, a Not allowed prompt displays. This prompt also occurs if the originating telephone is on a call when the diversion command is issued.

5Enter the password of the diverted telephone.

The buttons on your telephone mimic the buttons configured on the diverted set. The diverted telephone indicates that it is diverted, and it cannot be used until Hot desking is cancelled.

Cancelling Hot desking

You can cancel Hot desking from the originating or target telephone.

To cancel Hot desking

1Ensure that both telephones are on-hook before cancelling Hot desking.

Note: There can be up to a ten-second delay after the call ends before the system allows you to cancel Hot desking. This period can vary, depending on the call type.

2Cancel the feature:

Diverted telephone: Press the display key under the CANCEL prompt.

Live telephone:

a Access FEATURE *999. b Enter the password.

c Press CANCEL.

Configuring a new time zone on a remote IP telephone

If the IP telephone connects to the system from a different time zone than the system, you can reset the telephone to display the correct local time.

To configure a new time zone on a remote IP telephone

1At the telephone, enter FEATURE *510.

2Press CHANGE.

3Press * to toggle between + (plus) and - (minus). Use + if local time is ahead of system time; typically, you use + when the system is west of the local site.

4Enter the number of hours difference.

N0060600