Nortel Networks N0060600 manual Capabilities and Preferences Swca Call Group tab

		Chapter 6 DN records parameters 55
Table 14 Capabilities and Preferences - Capabilities tab (Sheet 3 of 3)
Attribute	Values	Description
Allow redirect	<check box>	Define whether this telephone allows assigned lines to be redirected.
		This must be selected to allow call forwarding outside the network (external
		call forward), including calls to a centralized voice mail system over a
		private network.
		Default: Cleared
Redirect ring	<check box>	Define whether the telephone rings briefly when a call on one of its lines is
		redirected by the Line Redirection feature (FEATURE 84).
		Also refer to “Trunk/Line Data, main panel” in the BCM 4.0 Networking
		Configuration Guide (N0060606).
		Default: Selected
Receive short tones	<check box>	Analog equipment, which is connected to the system with an internal or
		external analog terminal adapter (ATA2), responds only to tone dialing
		signals.
		Select this setting only if you have analog equipment connected to a station
		port.
		Default: Cleared
Silent monitor	<check box>	On two-line display telephones only, you can choose whether the telephone
supervisor		can be used to allow the Silent Monitor feature. Select the check box to
		allow this feature on this telephone.“Silent Monitor” on page 81“Monitoring
		Hunt Groups” on page 107.
		Default: Cleared

Capabilities and Preferences - SWCA Call Group tab

Although System-wide Call Appearance (SWCA) assignments are meant to be assigned to buttons with indicators, you can assign SWCA assignments to a telephone without assigning them to buttons using the fields on this panel. This is useful if you want to use the full range of SWCA assignments.

Use the SWCA Call Group tabbed panel to enable or disable Call 1 to Call 16 assignments for each sets. The administrator can configure the 16 SWCA feature codes on all the sets through administration.

Users can park or retrieve calls on any SWCA assignment, even if the call is not directly assigned to their telephone. However, the SWCA support codes (FEATURE *520, FEATURE *537 and FEATURE *538) only search for SWCA assignments that are assigned to the telephone where the feature is invoked. These codes are required for users who do not have buttons with indicators.

BCM 4.0 Device Configuration Guide