
26Chapter 3 System Software
Click one of the following links to connect with the type of information you want to view:
Panel | Task |
|
|
| “Setting clock control to local system” on page 28 |
Click the navigation tree heading to access general information about Date and Time management.
Figure 4 Date and time panel
Table 2 describes each field on the Date and Time panel.
Table 2 Date and Time panel fields (Sheet 1 of 2)
Attribute | Value | Description |
|
|
|
Date and Time Source | NTP | Set to NTP (Network Time Protocol) if the system uses a |
| Trunk | network server to determine the correct time and date. |
| Set to Trunk to use time and date settings from a CO through | |
| Manual | |
| an analog or ISDN line. | |
|
| |
|
| Set to Manual if you want to be able to manually configure the |
|
| time and date for your system. |
|
|
|
Network Time Protocol Settings
(Settings are active only if Clock Control Type is set to Network Time Protocol.)
NTP server address | <IP address> | The IP address of the server that controls the network time and |
|
| date. |
|
|
|