Siemens 810T manual P1 = P1=7 P1=4

01.93 3 Operating Sequences

3.1.4 Tool offset

0 Tool number

The input field marked P = º0º is intended for the input of a max. 8-digit ºtool numberº.

Normally entries are not required except when using flexible tool management!

Whether tool numbers are used or not is fixed in machine data (MD).

1 Tool type

Under identification º1º you enter the cutter centre point ºSº

( Reference Point: ºPº) into the ºTool typeº input field.

The input values ºP1 = 1º to ºP1 = 9º are available:

The adjoining diagram shows which values you should select for machining behind the turning centre.

P1=9 is valid when the cutter centre point ºSº is the reference point.

The adjoining diagram shows which values you should select for machining in front of the turning centre.

P1=9 is valid when the cutter centre point ºSº is the reference point.

P1 = 4	P1 = 8	P1 = 3
S	S	S
P	P	P
P1 = 5		P1= 7
S		S
P	P	P
S	S	S
P1 = 1	P1 = 6	P1 = 2
P1 = 1	P1 = 6
		P1= 2

S	S	S
P	P	P
P1 = 5		P1=7
S		S
P	P	P
S	S	S
P1=4	P1= 8	P1= 3

© Siemens AG 1990 All Rights Reserved 6ZB5 410-0EP02 3-5

SINUMERIK 810T, GA3 (BN)